Inspect the doorjamb and door frame for worn or damaged caulk.
How to fix sliding glass door seal.
Slide the sliding door open and take out the screws to remove the head.
Press the felt strips along the length of the doorframe and staple in place every 10 to 12 inches with the staples parallel to the felt strip.
How to fix sliding glass door seals that make noise step 1.
The felt compresses and prevents air from slipping through the cracks when the door closes.
If worn or damaged scrape away with a putty knife.
Due to fluctuations in weather and frequency of use it s possible for a sliding glass door s roller to require adjustment.
Take down any window shades or drapes.
Then lift the door up and off the.
Apply a coat of lubricant to the seal using the lubricant nozzle.
Staple felt strips inside the doorframe with a heavy duty hand stapler if the draft persists.
And it s probably less expensive to simply replace the door itself.
To view the previous video in this series click.
Be sure to remove debris big and small to ensure a smooth slide.
Run your finger along the rubber seal that stretches the length of the door.
Open the patio door so the sliding door is in front of the stationary section.
Remove the plugs from the roller.
Leave this coat for around an hour to.
If the door is noisy it s likely.
Wipe the area with a rag and apply new caulk with a caulking gun.
You have to replace the sliding glass door or replace the glass.
How to fix sliding door seals step 1.
Use the adjusting screws at the bottom of the metal door frame to raise or lower the rollers.
Begin the fix by cleaning the bottom door track.
Install the new weatherstripping as the directions indicate making sure to orient the flap correctly.
Remove the staples from.
Weatherstripping stops drafts cold unscrew and remove the header.
Tilt the top of the sliding door out far enough to clear the frame.
And i say that because it s not an easy fix.
Setup two sawhorses on the outside and add padding to the top of each.
Check the doorjamb and the frame surrounding the door.
Remove any additional staples or glue residue.