How To Hang A Laminated Wall Map

Put tape on the front of the corners all the way to the edge and then tape it to the wall but put the tape over your laminated corner.

How to hang a laminated wall map.

Pull it out of the tube and lay it on a clean flat surface. One end of the rope is hooked under the rail of the plate. The directions on the package were sufficient for us. At the time of publication the most recent version of the national geographic world map mural is 2013.

The frame is put onto the back of your plate with the included glue. You don t need any additional materials. Decide where you are hanging your map then measure and mark the wall lightly where the top corners will hit. I knew i would have to buy some wallpaper hanging supplies but i didn t anticipate that they would cost almost as much as the mural.

A couple of rolls should do it but please be careful. If your poster or map is too heavy for this method you can do a similar thing on the front. Check the fit and alignment. Spray the adhesive to half the board then unroll.

Gently roll it in the opposite direction it was packed in to take out some of its natural curvature. Place the command strips along the edges of the foam board s backside. The mural is actually three latex coated panels that are hung like wallpaper. Dry fit to the foamcore clip one short side of the map to the short edge of the foamcore.

The aluminium suspension system can also be used for a rope suspension. Use two nails or screws in the wall to hang up your print. Then let the map roll up. We ve listed our favourite ways to hang our wall maps below but before you start take a minute to properly prepare your map.