How to use them.
How to hang wall clock on drywall.
If you have a bathroom scale simply step onto the scale while holding.
Hanging the clock with a stud.
The position that you choose to hang the wall clock should be supported by a stud.
Okay so then you just stick the hook in the wall and it will look like this.
Use the stud finder to locate a stud in your desired hanging location.
A secure screw coming directly out of the wall works well for this clock.
To check whether you have a stud at the location of your choice you can use a stud finder.
You can trim a plastic bolt flush with its nut after installation.
As with the expansion anchor drive it in until it sits flush with the drywall.
Exciting picture i know.
If a stud behind drywall is available always use the stud with a screw coming straight out of the stud through the drywall exposing about 1 2 3 4 far enough so the head is on the inside of the clock of an inch outside the drywall.
Select a hollow wall drywall anchor rated to hold the weight of your item.
How to hang your wall clock.
The only safe method of hanging a clock is to secure it to a wall stud with a long eye screw.
A heavy clock may literally rip a nail or screw out of the drywall immediately after installation.
About 2 cm of the nail should stick out from the wall.
Then take your power drill and drive the threaded anchor into the drywall just like you would with a normal screw.
Plastic versions hold medium loads 10 pounds to 25 pounds in drywall and plaster.
Now position the nail on the spot and use a hammer to drive it inside the stud.
Once you have fixed a location mark it.
This was an old hole that i needed to patch up but i just stuck it in here to show you all.
Determine the weight of the item you ll be hanging onto the wall.
These are the support 2 by 4 pieces of wood behind the drywall and.
How to hang a heavy wall clock.
Mark the stud with a pencil at the proper height based on the hanger on the back of the wall clock.
How to hang something heavy into drywall without studs.
Bore a hole in the wall large enough to accommodate the toggle.
Fit the item to be anchored over the bolt then insert the toggle and tighten.
And then you hang your item.
Now you may hang the clock on the wall.