How To Install House Door Handle

Then insert the interior door handle and connect it to the latch.

How to install house door handle.

6 install the interior. Start by inserting the new latch into the latch hole. Remove the two screws from the latch plate on the edge of the door and remove the latch from the opening. Begin by removing the screws from the door knob on the interior side of your door.

Replace the existing strike and latch plates in the door jamb with the new ones provided with your set. With the new dead bolt and latch bolt in place fit the handle over the door s existing holes. Remove the screws from the face plate behind the handle on the exterior side of the door using a screwdriver or drill driver. Slide the faceplate over the door handle and snap it into place.

Install the latch determine whether you want to use a flat rectangular faceplate or a round drive in faceplate. Repeat this process to attach the other faceplate. Install the inside. How to install a door lock door knob deadbolt.

Remove all screws from the lever or doorknob on the inside. Most door handles have a standard backset of 60 mm or 70 mm so you shouldn t have any trouble finding a new door handle that fits in the existing holes in your door. Install the outside handle if your new door handle attaches to the door at a point below the lower borehole. When the latch is in place insert the external door handle into position.

Step by step directions step 1. In some cases door latch plate mortises might need to be cut or enlarged. Use the allen key provided in the door handle kit to lock and secure the faceplate. This allows you to pull the door.

Gatehouse door handle assembly and installation. There may be only one mounting screw at the base of the plate. Now secure the latch to the hole by inserting the screws on the screw holes and tightening them. For example if your old door handle had rectangular cover plates it s probably best to stick to a new handle with similar rectangular cover plates rather than switching to.

Step 3 install the exterior handle photo by ryan benyi. In this kit the hole for the allen key is at the bottom of the faceplate. To remove the dead bolt and latch bolt unscrew their faceplates located on the door s inner edge. Slide the adapter plate into the same hole in the rear of the door and screw these units in place.