10 reinstall panel assemblies and replace door trim.
How to install panel door on sub zero fridge.
To install the custom door panel partially insert a screw in the center of each mounting position on the hinge side of the door.
How to mount or remove panels from designer series doors and drawers.
Signals a situation.
With panel in position secure handle assembly to door by reinstalling handle mounting screws see figure 2.
3 position the edge of the.
700 series panel removal.
Make sure the built in unit is secured in place with anti tip brackets to prevent tipover when panel weight is added to open doors.
See also sub zero standard and accessory handle information.
Refer to the product installation guide for further installation information.
To install the handle reverse the above steps.
Designer custom door or drawer panel installation.
Signals a situation where minor injury or product damage may occur if you do not follow instructions.
Framed handle is loose.
Assembly from door see figure 2.
Grasp the trim on one side of the door near the bottom and pull the trim away from the refrigerator.
Loose handle on sub zero custom panel.
If panel is less than 1 4 6 mm thick install chipboard filler panels behind panel.
Slotted holes on the mounting bracket should slide under screw heads to support the panel.
Slide door panel into door trim frame see figure 2.
States a hazard that may cause serious injury or death if precautions are not followed.
Panel mounting brackets for designer units.
Overlay panels must be a minimum of 5 8 thick to support mounting the handle.
States a hazard that may cause serious injury or death if precautions are not followed.
See also framed door panel installation instructions.
Engage the tabbed bracket to the handle side of the door then slide the hinge side mounting bracket onto positioning screws.
Pull the trim strip down to pull it out from under the top trim.
Install custom panels on a designer formerly integrated product.