How To Install The 910 Programmable Door Lock

Hold press and hold the lock button while installing battery pack l.

How to install the 910 programmable door lock.

Hand thread the screws then tighten them using a screwdriver or power drill. Switch 2 if in the up position this will enable the 30 second auto locking feature and if the switch is in the down position this will disable the auto locking feature. Located on the interior side of the lock there are 4 switches. B d 2x install strike aa x4 a b c l l ensure correct polarity.

Attach the interior part of the deadbolt lock by inserting the two provided long screws through the interior plate the two screw holes in the bolt and into the exterior side of the lock. For best results use new non rechargeable alkaline batteries only. Remove the existing deadbolt lock from the door. How do i activate disable the auto lock feature on my smartcode 909 910 deadbolt or 911 912 lever.

Install the kwikset 910 z wave lock into your door. Pop off the cover and remove the screws which hold the deadbolt into place after which remove the deadbolt from the door and remove the existing latch and strike as well. Install the new deadbolt into the side of the door and test that the bolt. This master lock video demonstrates how to install and operate the electronic programmable keypad deadbolt door locks.