How To Level A Garage Door With Springs

This will tighten the screws and raise the door.

How to level a garage door with springs.

First the floor may be so out of level that the garage floor does not meet the bottom edge of the door. If the garage door is level tighten the set screws 3 4 turn past the point at which they meet the hollow shaft. Remember to release the vise grip each time you get to step nine. Garage door springs offset the weight of the door and allow it to open and close with ease.

A problem with the spring tension could cause the door to open or close unevenly improperly or at the wrong speed and adjusting the springs will likely solve the problem. Move to the other side of the garage door where the gap is. Climb up to the drum and use a marker to make one mark on the drum and another approximately one fourth of an inch above the mark on the drum if the gap under the door is 1 inch or more. Second and far more critical is when the garage floor has begun to tilt backward toward the house.

Garage springs are under an extreme amount of tension and either stretch or torque providing enough force to help you move the door. Garage doors come in different styles that use two different types of springs. Garage door springs act as a counterbalance to the weight of all garage doors making them easier to open and close. Start with the side which is opposite to where the gap is.

Adjust the springs on both sides of the door the same way. However an out of kilter garage floor may require leveling when two critical scenarios happen. Once the spring is free of tension remove from its track hanger. Open it just as wide as you can without hitting the garage door opener s stop bolt and place a clamp on the track on both sides to keep the door in place.

So with a gap on the left side you will begin leveling on the right side. If the gap is less than an inch make the marks one eighth of an inch apart. If they have a lot of give you may want to consider replacing them. If the bottom of the garage door is still not level repeat this process following steps six through nine with another mark or marks until the door is level.

If the door was closing too quickly move the spring to the next higher hole on the bracket.