Installing Metal Roof With Elevated Section

Before you install metal roofing repair any damage to the wood under the shingles.

Installing metal roof with elevated section.

Installing low slope metal roofing attain high marks for low slope roof installation. Use 1 1 4 inch nails to cover the outline of the roof with strips of metal eave flashing also called edging. As with transition with gambrel flashing it is preferable to install the lower roofing panels then the gambrel flashing then the upper roofing panels. A typical gambrel style roof has two of these ridges one on each side of the peak and is commonly called a barn roof.

Place corner pieces where panels will meet bends at the edge of the roofing. If there are gutters installed on the eaves the eave flashing should be installed to overhang the lip of the gutter by about 1 2 inch. When installing a metal roof people usually installed over battens rather than solid wood surfaces or use wrong fasteners or do not overlap the panels adequately. Dan lane vice president installation manager american metal.

Then cover the entire roof with a layer of insulation and secure it with a staple gun. You can use 1 inch nails for the installation of eave flashing. The eave flashing or edging is just the steel metal strips used to cover the entire perimeter of the roof. Covering the entire low slope section with a water and ice shield is the best way to ensure that the roof does not leak.

For successful low slope metal roof installation mark graham. Email protected follow us on. Metal roofing 101 diy steel roofing installation over shingles subscribe. Changes to a steeper roof below such as between sections h and i.

You are essentially sealing off the metal roof with this flashing and you need to make sure that is securely fastened.