Installing New Siding Over Asbestos Chingles

Measure the house for siding and the backer board.

Installing new siding over asbestos chingles.

Inspect the outside of the home for any damages to the asbestos siding. This practice is not recommended for a number of reasons. However removing the asbestos siding first though more expensive is the best alternative in the long run. If the asbestos is in good condition a good paint job may look as good as the new vinyl siding.

First the siding installation process itself nailing into the existing boards or tiles is enough to disturb the existing material and create a dangerous condition. A common remodeling practice is to install new vinyl or aluminum siding over cement asbestos shingle siding as well as over many other older siding materials when the old siding has become damaged leaky or cosmetically ugly. The simplest way to do this is to use a tape measure to. Is there any value to wrapping the house in tyvec first before applying the vinyl siding.

Nail it in place using several nails a few inches apart until the top of the plastic is fully attached. Although i do not recommend siding over existing siding i suppose a case could be made for doing so if you had an asbestos shingled house that was in great shape and you wanted to retain the fire retardant protection of the asbestos but still reside the house cheaply. How to put siding on over asbestos step 1. Install the vapor.

Place the top edge of the plastic sheeting at the top of the exterior wall above the siding. Applying a layer of sheathing or sheets of foam insulation over the asbestos then covering it with vinyl siding is a common practice. Some experts recommend screwing rather than nailing when new siding is installed over existing asbestos cement siding. The plastic is used to create a barrier to the elements as well as prevents the siding from rubbing against the painted asbestos siding.

Some people attempt to solve the problem of deteriorating asbestos siding by installing vinyl siding over top of it. A typical procedure is to install furring strips on the existing wall avoiding breaking the existing siding. But be sure to check your local building codes first to see if it is allowed in your area. Make sure that there are no loose or.

As far as removing the asbestos and doing the job right i d make a story pole and see where the courses of the vinyl siding will fall. If the shingles are to be removed they should be wetted during the process. It is a stick build home with 1x5x3 4 sheathing covered with roofing felt and a single layer of asbestos shingles.