For larger projects like heavy wall art or projects that need to be waterproofed like wine cork coasters you should use glue that bonds well to multiple surfaces.
How to glue cork tiles to wall.
For best cork wall tile installation results lay tiles with staggered joints brick pattern.
Carefully line up your cork roll to its final resting spot on the wall and press onto adhesive.
How to make cork stick to the walls.
The wall should be as smooth as possible for the best.
Apply adhesive with a brand new 3 8 inch or less with a high quality microfiber roller.
Apply liquid adhesive over the center point of the four quadrants marked on the wall.
Adhesive must be wet for cork installation.
Place the cork against the surface and hold it in place for at least one minute if using contact cement or gorilla glue.
If the surface is vertical hold the cork an additional two minutes to assure that it stays in place.
Lightly sand the surface of the wall with 220 grit sandpaper if you have a textured wall.
Finally use a wall roller to firmly press the material onto the wall working out.
Allow the glue to become tacky.
Apply cork adhesive to wall one area at a time.
To repair thin corkboard sheeting that has pulled away from its backing board apply lines of glue to either the cork or the backing material spreading the glue thin with your finger or a foam brush.
Open the windows to increase air circulation and ventilate the space.
Roll a section of adhesive that is approximately four foot square.
Let the wall thoroughly dry before proceeding.
This adhesive is greenguard gold certified and has a fast acting strong bond to virtually any surface for wall or ceiling applications.
Apply a bead of glue over the back of the material being adhered to cork.
Saturate your brand new microfiber roller with wakol d 3540 adhesive and roll the glue onto the wall and back of tiles.
Glue is troweled on with plenty of open time and you may need to roll the edges if there is a seam.
Use liquid nails fuze it.
For maximum bond allow to dry for 24 hours.
If adhesive dries to wall prior to installation scrape off and reapply.
To use dot the glue on one of your materials and firmly hold the two materials together for a few seconds.
Put on rubber gloves and a dust mask to protect your eyes and lungs from the adhesive itself and the fumes it emits.
Allow the adhesive to set for 10 to 20.
A utility knife can be used to cut wall cork board tiles.
Wood glues also work well for cork.
Mix tiles from various cartons to maintain natural variation of color and pattern.
Pour the adhesive into a new clean new paint pan.
Clean the wall with an all purpose cleaner and degreaser.